Products

This Relaunch bungee set is specifically designed for the NEO D/LAB kite. Please make sure that the model year of the relaunch bungee set and the k...

This item for the CLICKBAR and TRUSTBAR includes: 1x release pin for Iron Heart VI with preassembled bungee – This component is built into the Iron...

Wing: Used for batten pockets

Wing: Used for main tube tip seam reinforcements, canopy edge reinforcements, and stabilizer.

This article for CLICKBAR includes: 1x Right cover incl. bearing + winder gear - In case the winder COVER gets damaged, you can replace it easily u...

Duotone Rocket Tool – Your All-in-One Tool for Kite, Wing and Board The Duotone Rocket Tool is the perfect compact tool for all kiters, wingers, an...

This article for CLICKBAR includes: 10x pair of rubber cord with preassembled cord ends - If the rubber bands for securing the lines tear, you can ...

This article for CLICKBAR includes: 1x pair of rubber cord with preassembled cord ends - If the rubber bands for securing the lines tear, you can r...

This article for CLICKBAR includes: 1x pair of rubber plug left and right - You can open these to flush your bar and close them again to prevent an...

This line for the TRUSTBAR includes: 1x Safety Bungee Line for TRUSTBAR If your safety line is damaged, you can replace it with this item.

With its five battens, state-of-the-art profile and practical mix of materials, the EPX SAIL begins planing easily, has a stable draft position and...

This article for CLICKBAR includes: 1x Left Winding Post Cover in red (Pantone 2028) - to mark the LEFT side in red 2x red (Pantone 2028) adjustab...

The PH3 bit size fits perfectly with the footstrap screws. The balanced handle size guarantees maximum power when tightening the screws.

Depending on selection following screws are included: 8 x Schraube DIN 965 – M6 x 14 mm V4A 8 x Schraube DIN 965 – M6 x 18 mm V4A

This item includes: 8 x Fin Screw 16mm 4 x Fin Screw 12mm The fins require the following screw lengths: Center fins & NQ middle fins: 12mm All...

This item includes: 2× M6 × 11.2 cm screws These screws are specifically for mounting the handle.

This article for CLICKBAR includes: ALL standard screws of the Clickbar: 4x M4x16 – for replacing left Winding Post Cover and right Winding Post Co...